FAQ
How do I synchronize screens on GP-Viewer EX with screens on the GP?

Setup procedures to synchronize screens on GP-Viewer EX with screens on the GP are as follows.
 
1. GP-Pro EX Ver. 3.0 or later: GP-Pro EX Ver. 2.7 or earlier:
  Start up GP-Pro EX.
In the [Project] window, click [Display Unit].
Start up GP-Pro EX.
In the [System Settings] window, click [Display Unit].
 
   
2. On the [Remote Viewer] tab, check off "Enable Screen Changes from Client" in the Remote Viewer area.
 
   
3. Save the settings and transfer screen data.
4. Start up GP-Viewer EX and set "Synchronous Mode" for Screen Mode.
 
 
NOTE
As for the screen synchro system, please refer to the following comparisons with GP-Viewer.
GP-Viewer
GP-Viewer EX
Description
Asynchronous
Asynchronous Mode
Enables to switch screens on the PC (client). Switching a screen on the PC does not synchronize with a screen on the GP.
GP Synchronous
Synchronous Mode
+
Above Settings
Disables to switch screens on the PC (client). Switching a screen on the GP synchronizes with a screen on the PC.
Full Synchronous
Synchronous Mode
Enables to switch screens on the PC (client). Switching a screen on the PC synchronizes with a screen on the GP, and also switching a screen on the GP synchronizes with a screen on the PC.

Contact Us | Tech Support | Customer Care | Repairs | Privacy Policy | Terms of Use | Prop 65
Copyright (c) 1996-2019 Schneider Electric Japan Holdings Ltd. All Rights Reserved.