FAQ

 Error Information


Errors displayed with LT3000 Series are shown below.

  Error Code Error Message Description Solution
001
Module type error
The module setting type is not supported.
The project file might not have been sent properly. Transfer the project file again.
002
Setting value error
The variable type allocated to the terminal is not correct or the terminal settings are not correct.
003
Device out-of range error
The variable address allocated to the terminal is not correct.
004
Excess terminal settings
The number of terminals is not correct. (Too many terminals)
005
Terminal setting order error
The terminal number is not in ascending order.
006
Terminal registry short
The number of terminals is not correct. (Too few terminals)
007
Module settings duplicated
The module is registered twice.
008
Excess module settings
The number of modules is not correct. (Too many terminals)
009
Driver settings duplicated
The driver is registered twice.
010
I/O settings inconsistent
The terminal settings are not correct (unit I/O settings are not consistent).
011
Bit/Integer type inconsistent
The terminal settings are not correct (unit variable type settings are not consistent).
012
Setting level value error
The driver is not correct.
013
Data obtaining address error
The driver information is not correct.
The controller information is not correct.
014
Driver ID error
The driver/unit registry results in an error and have not been registered.
015
Module setting order error
The module number is not in ascending order.
050
I/O board ID different
The connected I/O board is not correct.
The display type might not be correct. Check the display type and transfer the project file again.
051
Unsupported model error
The driver foes not support the model.
052
IO initial error
The I/O board initialization fails.
The project file might not have been sent properly. Transfer the project file again.
053
IO ROM error
There is a problem with the system ROM on the I/O board.
054
IO RAM error
There is a problem with the system RAM on the I/O board.
055
IO microcomputer error
There is a problem with the microcomputer on the I/O board.
056
IO IF RAM error
There is a problem with the system I/F RAM on the I/O board.
057
IO E2PROM error
There is a problem with the system E2PROM on the I/O board.
100
I/O board error
The I/O board does not respond.
101
Special IO parameter error
There is a problem with the special I/O parameter you set.
The parameter is not correct. Reset the parameter and request the parameter change.
102
Acceleration/Deceleration table creation error
There is a problem with the special I/O parameter you set.
The parameter is not correct. Reset the parameter and request the acceleration/deceleration table creation.
200
Integer type data read error
Reading the integer type terminal data value failed.
The project file might not have been sent properly. Transfer the project file again.
201
Bit type data read error
Reading the bit type terminal data value failed.
202
Integer type data write error
Writing the integer type terminal data value failed.
203
Bit type data write error
Writing the bit type terminal data value failed.


Contact Us | Tech Support | Customer Care | Repairs | Privacy Policy | Terms of Use | Prop 65
Copyright (c) 1996-2019 Schneider Electric Japan Holdings Ltd. All Rights Reserved.