Specify the word address to control the Window.
This can be set to either a PLC address or a display unit's
internal device address (System Data Area).
When many parts are running from a window, you
can sometimes speed up screen display by using a display unit's
internal device addresses.
Window Specification
Select the method to display the Window.
Constant
Set the Window Number
Address
Four consecutive words are used starting from [Window Control
Address], the Window Number and position are stored and designated
indirectly.
Window Number
Shows the address ([Window Control Address] + 1) that defines
which Window to display.
Window Display Position (X Coordinate/Y
Coordinate)
Displays the address that stores the window position. The X
Coordinate: [Window Control Address] + 2. The Y Coordinate: [Window
Control Address] + 3.
This stores the coordinates of the Window's top-left corner.
The following positions are the starting
coordinate point when a display unit's orientation is set to
[Portrait].
Display units except GP-4100 Series:
Bottom-left of the screen (0,0)