|
Error Message
|
Cause and Solution
|
Reference
|
|
RAAA012:The project data contains functions
that are not supported by this model.
|
Simulation does not support all features. You
can only simulate supported features.
Please refer to the next cell for unsupported
features.
|
 33.7.1 Restrictions on
Simulation
|
|
RFAJ034: Error has been responded for device
read command (Error code: ***)
|
Failed to read device. For error codes, see the
MX Component manual.
|
—
|
|
RFAJ035: Error has been responded for device
write command (Error code: ***)
|
Failed to write device. For error codes, see
the MX Component manual.
|
—
|
|
RFAJ049: Unknown devices exist in read
devices
|
Please check if the device address range,
device/PLC settings, and CPU type are correct.
|
—
|
|
RFAJ050: Unknown devices exist in write
devices
|
Please check if the device address range,
device/PLC settings, and CPU type are correct.
|
—
|
|
Please stop and exit the simulation to
continue.
|
The user tried to close the Editor during
simulation.
Before closing the Editor, complete
simulation.
|
33.2.1
Procedure - Checking Display Unit operations on the Computer
|
|
Cannot change language during simulation.
|
The user tried to change the operating language
in the Editor [Option Settings] when simulation was in
progress.
Before changing the operating language,
complete simulation.
|
3.7.5 Preferences
Settings Guide
|
|
The simulation could not be started.
|
Simulation does not start due to some
problem.
The file may have been broken. Reinstall GP-Pro
EX.
|
1.3 Operating
Environment
|
|
Cannot input the key code during
simulation.
Exit simulation and then enter the key
code.
|
Before inputting the key code, complete
simulation.
|
|
|
Failed to start Simulation due to project
error.
Run Error Check to find problems.
|
The simulation did not start due to a problem
with communication with a connected device. Run the simulation
after an error in the project file is corrected.
|
—
|
|
Unable to connect to GX Simulator.
|
GX Simulator is not running, or CPU type is
different. Please first start GX Simulator. Please check the CPU
type set up in GX Developer.
|
—
|
|
MX Component is not installed.
|
Please re-install MX Component on the
computer.
|
—
|
|
Failed to connect to GX Simulator (Error code:
***)
|
Please restart both GP-Pro EX Simulation and
GP-Developer. For error codes, see the MX Component manual.
|
—
|
