T.3.10 A screen prompting you to re-transfer appears after you
have transferred the file
Does the transfer screen appear again after
you finish transfer and restart the unit?
Cause
For the GP-3300 Series, when the [Revision] selected in [Model]
is [Greater Than Or Equal to Rev*-4], and the revision for the
receiving display unit is earlier than Rev 4, transfer fails. The
same symptoms may occur if downloading from a CF Card or USB
storage memory loader.
However, for AGP-3310T/3360T, transfer is possible regardless of
revision.
Solution
This problem occurs when you create a new project and select
[GP-33** Series] as the [Display Unit] and [Before Rev*-4] for the
[Revision], and you add functions that are not supported by display
unit models Rev 3 or earlier. As a result, transfer fails.
In the [System Settings] [Display] tab, click [Change Display
Unit]. Set the [Revision] to [Before Rev*-4]. Then, delete all
functions that are not supported by models before Revision 4, and
perform transfer.
The following are functions that are not supported by models
before Revision 4.
T.3 Problems with Display
operation
|