Initial Screen Number
Set the number of the screen that should appear at startup.
11.2 Choosing the Screen to
Display when the Display Unit Turns on
Data Type of Display Screen Numbers
Select the data type of the screen number specified when
changing screens from [Bin] or [BCD].
Change Screen from Display Unit
Set whether or not to update the settings in the device/PLC when
the screen is changed from the display unit.
Reflect in Device/PLC
When changing the screen from the display unit, you can define
whether the screen number is updated in the device/PLC's [System
Area Start Address]+8 (Change- to Screen).
Select the check box when you want to change screens from both the
display unit and device/PLC.
11.5 Changing the Screen
from both Touch and Device/PLC
-
When changing screens from the device/PLC,
despite the setting in the [Relect in Device/PLC] property, the
screen number is updated in the display unit's System Data
Area.
For information on the System Data Area, see the following.
A.1.1.2
System Data Area (Direct Access Method)
-
If you are not using the [Reflect in
Device/PLC] setting, design your system so that after a screen
change you clear (0) the contents of [System Area Start Address]+8.
Without clearing the address content, screen changes may not run
properly, or screen changes may occur unexpectedly.
-
If you are using a ladder program to clear (0)
[System Area Start Address]+8, do not use the [Reflect in
Device/PLC] setting.
Start Time
Set the time it takes for the display to start up after the
power turns ON from 0 to 255 seconds.
Standby Mode
Select the standby mode from [None], [Screen OFF], or [Screen
Change].
-
This feature runs when this property is set to
[Screen OFF] or [Screen Change], and the System Data Area's [Screen
Display ON/OFF] address value is 0(h). For information on the
System Data Area, see the following.
A.1.1.2
System Data Area (Direct Access Method)
The screen does not change to the standby
mode.
If the following operations do not occur for
the length of time specified in the [Standby Mode Time], the screen
display turns OFF.
-
For models that support changing the backlight
color, when the backlight changes to red, the screen continues to
display even when the Standby Mode is set to [Screen OFF].
-
To display the screen again, touch the screen
once.
If the following operations do not occur for
the length of time specified in the [Standby Mode Time], the
display changes to the screen defined in the [Change- to Screen in
Standby Mode] field.
Standby Mode Standby Mode Time
Set the time to automatically clear the screen to protect the
display from 1 to 255 minutes. Automatically clears the screen
display or changes to the specified screen when the specified time
passes without any display operations.
Change- to Screen in Standby Mode
If [Screen Change] is selected for [Standby Mode], specifies the
base screen number to switch to after [Standby Mode Time]
passes.
-
Set the screen number from 1 to 9999 when the
[Data Type of Display Screen Numbers] is [Bin], and from 1 to 7999
for [BCD].
-
If the global window is displayed, the window
remains even when the base screen changes.
