Available extensions differ depending on the model. Please check
whether your model supports the feature before use.
Function
Expansion Memory Settings
Select [8M] to increase the screen area. You can increase the
maximum number of indexes in the text table, increase the maximum
number of alarm addresses to monitor, or extend the alarm
function.
Device Monitor Settings
Specifies whether to use the device monitor feature.
Load Text Table
Specify whether to enable text table loading.
Load
Select [CF Card] or [USB Storage] for the location of the text
table file (CSV).
Read File at Startup
Specify whether to read the text table file when starting up the
display unit.
After Update, Delete File
Specify whether to delete the file after updating the text
table. This is specified when [Read File at Startup] is
enabled.
Ethernet
Multilink Settings
Specify whether to enable EtherNet Multilink.
Action Mode
For the project transfer operation, set the display unit to
either [Master] or [Slave].
Master IP Address
Input the IP address of the Master display unit.
Filtering
Click to display the [Filter Settings] screen.
Allow Connection Only to Specified IP
Addresses
When the check box is selected, only slaves with the IP address
registered in the list displayed below can be connected.
Operation
Lock
Specifies whether to use the Operation Lock feature. When you
select the [Operation Lock] check box, touch operation from other
display units is locked during operation with one display unit.
Lock on Screen Touch
When the check box is selected, touching the screen of a display
unit locks the touch operation of other display units.
Timeout
When there are no new touch operations on the display unit that
activated the lock, set the period in seconds until the operation
lock is released.
Compatibility
Click to display the [Compatibility] dialog box.
When a project file created in GP-Pro PB III for Windows is
converted, it may operate differently in GP-Pro EX. This dialog box
aligns GP-Pro EX to match features in GP-Pro PB III for
Windows.
When this check box is selected, the method
of filling in parts will be the same as GP-Pro PB III for Windows.
In GP-Pro EX, filling in Parts may not occur in the converted
project file.
When the Window Part check box is selected,
upper left of the base screen is used as the coordinate position of
Window Parts even when Window Part is placed on the load screen. In
GP-Pro EX, the upper left of the load screen is used as the
coordinate position of Window Part.
When the Draw Using Standard Font check box
is selected, text will be displayed in Gothic Font even then it is
standard font and text size is larger than 32 X 32. In GP-Pro EX,
text will display using Mincho font.
