Interlock
Designate whether or not to use the Address and Security Level
when using the Interlock Feature (a feature that enables Touch only
when the conditions are satisfied).
Use an Address
This function allows input only when the bit in the [Interlock
Address] matches the state in the [Touch Enable Condition]
property. Select the check box to use Interlock.
Interlock Address
Specify the bit address used in conjunction with the [Touch
Enable Condition] property. Touch is enabled (disabled) depending
on the state of this address.
Touch Enable Condition
Select the condition that enables touch.
Touch is enabled when the defined [Interlock
Address] is ON.
Touch is enabled when the defined [Interlock
Address] is OFF.
Use Security Level
When operating the switch, touch operations are enabled when the
security level is higher than the operation screen.
Specify the security level, from 1 to 15.
Delay Feature
Select whether or not to use the delay feature. This function
delays the effect of touching a switch by the specified amount of
time.
-
Regardless of the System Settings window,
[Display Unit] page, [Operation] tab's [Touch Panel Detection]
option, operation is enabled when touched.
-
This function cannot be used with a Selector
Switch.
-
When used with Visibility Animation, and the
switch changes between visible and invisible, the switch operates
as follows.
ON Delay: Delay status is canceled and the switch function does not
work.
OFF Delay: Delay Status continues and the switch function
works.
Double Touch: Delay Status continues and the switch function
works.
Delay Action
Choose the condition that will enable the switch feature: [ON
Delay], [OFF Delay], or [Double Touch].
If you continuously press the switch for the
period designated in [Delay Time], the Switch feature is
enabled.
The switch will not operate if you release it
before the [Delay Time] has elapsed.
Turns OFF when the amount of time specified
by [Delay Time] has elapsed after releasing the switch.
Function when [Bit Action] is set to [Bit
Momentary].
After pressing the switch the first time, if
you press it again within the [Standby Time] period, the switch
feature is enabled.
The switch is not enabled when you press it
for the second time after the [Standby Time] has elapsed.
Delay Time
When the [Delay Action] is [ON Delay] or [OFF Delay], set the
time period for the delay. The value can be from 1 to 30
seconds.
Standby Time
When the [Delay Action] is [Double Touch], set how many seconds
the switch will wait for the second touch after the first touch.
You can enter a value of between 2 and 30 seconds.
