-
Please refer to the following for the models
supporting Selector List.
1.5 Supported
Features
-
When multiple selector list parts are placed,
multiple selector function lists cannot be displayed at the same
time.
-
It cannot be set on the window screen.
-
Even when you set it as Call Screen on the
window, nothing will be displayed.
-
The window size for selector function lists is
defined in four pixel units.
-
When using Call Screen or some other function to
create a window, if the position of the window is not in a 4 pixel
interval, the position will be slightly adjusted.
-
When the window is angled 0 or 180 degrees and
the horizontal width is not in 4 pixel units, and if a scroll bar
is required, the scroll bar will be slightly smaller to adjust to
the 4 pixel interval.
If there is no scroll bar, the horizontal width of the display of
the selector function list will be smaller.
(Moves by a maximum of 3 dots)
-
When the angle is 90/270 degrees and the
horizontal width is not 4 dots, the area in the last selector
function list will be displayed larger in accordance with the total
4 dots. (Moves by a maximum of 3 dots)
-
At the top of each screen (including
header/footer), even if you draw multiple Selector List parts with
the same Parts ID, only the first drawn Selector List will display
and run. In the same way, if you use the [Call Screen] command to
load a screen with a Selector List with the same Parts ID, only the
first displayed Selector List will run.
-
The Selector List adjusts its horizontal width to
accommodate the maximum number of characters in its list. You
cannot make the horizontal width smaller.
When [Font] is set to [Image Font], depending on the font you set
in the [Select Font] field, the part width may be wider than the
displayed item names. to match the width of items, please select
any [Font Type] other than [Image Font], or change the selected
font.
-
In the [Font] tab, when [Font Type] is [Image
Font], depending on the font size the drop-down cursor in the part
may not display.
Please adjust the size of selector list part until the drop-down
cursor is visible.
-
For restrictions on using [Anti-alias] with Image
Fonts, see the following.
6.6.2 Restrictions for Image
Font
