On the [Lamp Feature] tab, select the [Lamp
Feature] check box and click [Copy from Switch]. The same address
as the one designated on the [Switch Feature] tab will appear in
[Bit Address].
On the [Color] tab, set the OFF state switch color
(green).
In [Select State], select [ON] and set the ON state
switch color (red).
As needed, set the text to display in each state on
the [Label] tab, and click [OK].
When you select a switch and press the [F2]
key, you can directly edit the text on the label. When [Text Table]
is selected, you can change the current Text Table.
to place a switch on
the screen.
