Displays the list of the I/O Driver registered in the current
edited project file. Select the I/O Driver to display in the Driver
Detail Display Area.
Driver Detail Display Area
From the simulation, you can check the performance operation of
the I/O Driver selected from the I/O Driver List.
The Display Method differs depending on the selected I/O
Driver.
Introduction
Change the Detail Screen/Basic Screen.
Current Value
Bit Type
Icon displays (ON) / icon
displays (OFF).
When you click , it switches ON/OFF
for some I/O Drivers. You cannot perform output operations.
DIO Driver, FLEX NETWORK Driver's DIO, LT
Built-in DIO (STD) Driver's standard I/O, EX module (EXM) Driver's
DIO I/O
The icon moves the focus as
defined by the [TAB], [Up], [Down], [Left], and [Right] keys. Also,
you can switch ON/OFF with the [SPACE] key.
LT Built-in DIO Driver (STD)'s PWM Output/PLS
Output, EXM Module (EXM) Driver's Analogue IO
Icon moves the focus as
defined by the [TAB] key.
Current Value
Integer Type
Displays numeric values. When you start
typing, the current value display stops.
Enter numeric values and press the [ENTER] key. If you press a key
other than the [ENTER] key or do other operations, anything you
type is canceled.
Switch Decimal/Hexadecimal
When is displayed, decimal
and hexadecimal systems are supported. Click to display the numeric
numbers in hexadecimal and click again to display them
in decimal. You can switch the decimal/hexadecimal for every
variable.
Slider Bar
When you select the FLEX NETWORK Driver, you can move the slider
bar to display the current value in the edit box and the box below
the slider bar depending on the position of the knob.
Click the [ENTER] key to update the current value on the slider
position.
In the edit box you can move the focus
with the [TAB] key.
Range
When you select the analog of the FLEX
NETWORK Driver, select the Input/Output range.
I/O Driver Change Tab
Displays tabs of displayed I/O drivers. Click a tab to switch to
the individual I/O Driver settings.
Change View
Arranges the windows
into layers in the Driver Display Area.
Arranges the windows
to the upper and lower halves of the Driver Display Area.
displays (ON) / icon
displays (OFF).
is displayed, decimal
and hexadecimal systems are supported. Click 
you can move the focus
with the [TAB] key.
Arranges the windows
into layers in the Driver Display Area.
Arranges the windows
to the upper and lower halves of the Driver Display Area.
Maximizes the windows
in the Driver Display Area.