USB
Select when using a USB cable to transfer screens.
-
When connecting the USB data transfer cable
(CA3-USBCB-01) and the ZC9USCBMB1 cable or standard USB cable (Type
A mini B), and in the [Transfer Tool] you click [Receive Project],
[Display Unit Information], or [Send Web site], the [Select USB
Cable] dialog box will display. Please select which USB cable to
use.

[A to A (Host to Host)]: Select when using CA3-USBCB-01.
[A to Mini B (Host to Slave)]: Select when using ZC9USCBMB1 or
standard USB cable (Type A mini B).
LAN
Select when using Ethernet (LAN) to transfer screens.
LAN Auto Setting
Select to automatically search all display units on the
network.
Port (Search)
When [LAN Auto Setting] is designated, set the port number used
during search.
PASV
Select if [LAN] is selected but data cannot be transferred due
to network security.
Modem
Select this option to use a modem to transfer projects.
Phone Number
Enter the phone number for the modem.
Register Telephone Number
Registers telephone numbers. You can register up to 100 phone
numbers.
Delete Telephone Number
Delete registered phone numbers.
COM
Specify when transferring projects using a COM port.
Port
Select the COM port to use from COM1 to COM9.
Baud rate
Select the communication speed from
9600/19200/38400/57600/115200. Select the same speed as you
selected in [Modem] in the system settings.
Transferring CF Files
Specify whether to send the data in the CF Card folder to the CF
Card in the display unit. If you do not wish to replace the data on
the CF Card, clear the check box.
Transfer Site Data
Specify whether to send the standard HTML template in the folder
set for [Data Transmission] in [Site Transfer Settings].
37.20.1 Standard
Template HTML Settings Guide
Auto
The project to be transferred is compared with the project on
the display unit. If they are the same project, only updated or
added screen data are sent.
When sending a new or different project, the whole project is
sent after you click [OK] in the confirmation message.
All
Sends the whole project to be transferred. Overwrites the
existing project on the display unit.
Retain retentive variables
Transfer the project and retain the current values of the
retentive variables.
Auto
When you send the project, GP-Pro EX automatically compares
between the project system version and the GP system version, and,
if necessary, downloads the system program*1, the protocol
program*2, and the font*3 to the display
unit.
These items are downloaded in the following cases:
-
When you perform a transfer when the display unit
has no data (factory default)
-
If the system program (Runtime) version stored on
the display unit is older than the GP-Pro EX version.
-
When old versions of protocol programs (drivers)
are stored in the display unit, or when project device/PLC settings
have been added or changed.
-
When a font not in the display unit was used in
GP-Pro EX.
Forced transfer
After you format the GP and send a project, GP-Pro EX will
forcibly download the system programs*1, protocol programs*2, and fonts *3 to the display unit.
These are downloaded even if the GP-Pro EX system is a previous
version of the current system on the display unit.