-
When sending a project, data stored in the
display unit's backup SRAM is deleted.
-
When sending a project, the necessary system
programs, protocol programs, and fonts are downloaded to the
display unit. The transfer will take a few moments.
Downloads occur in the following cases:
-
When you perform transfer when the display unit
has no data (factory default)
-
If the system program (Runtime) version stored
on the display unit is older than the GP-Pro EX version.
-
When old versions of protocol programs (drivers)
are stored in the display unit, or when project device/PLC settings
have been added or changed.
-
When a font not in the display unit was used in
GP-Pro EX.
When a download occurs, the display unit is reset. After
restarting, the transferred screens appear.
-
When the display unit is offline, the project
cannot be transferred.
-
During the transfer, the display unit changes to
Transferring mode and communication with devices/PLCs is
suspended.
-
When a problem is found with the system program
on the display unit, an error message appears on the display unit.
Transfer the project file again.
-
You cannot transfer the project file to a
different model. to perform transfers even between display units,
except for GP3200 Series, one of the following conditions must
apply.
-
Models that do not support the control
feature.
-
Models equipped with DIO board
-
Models with FLEX NETWORK connections
-
For GP-3300 Series models, when [Revision] is set
to Rev*-4 or later, the transfer fails if a model before Revision 4
is used. However, AGP3310T/3360 models can transfer project files
regardless of revision.
