When selecting the [Reflect in Device/PLC]
check box, the screen number defined as the start up screen is
written to the [Change- to Screen Number] address. When the
[Reflect in Device/PLC] check box is cleared, the screen changes to
the screen number defined in the [Change- to Screen Number]
address. but if the screen number does not have [Change- to Screen
Number] values, the screen set as the initial screen number will
display.
When you select the [Reflect in Device/PLC]
check box, a screen change initiated by touch will write the
current screen number to the [Change- to Screen Number (1 Word)]
address. If this check box is not selected, and you change screens
using a switch, not only is the screen number not written to the
device/PLC, but there may be instances when the device/PLC cannot
initiate a change screen operation.
, and place the Switch
on the screen.
icon will appear
next to the switch on the screen editor. Click this icon to jump to
the designated screen. This feature is useful for checking the
screen setup.