Group Number
Set the sampling group number you want to display on the screen
from among the sampling groups created in [Common] -
[Sampling].
Block Number Specification Address
When the designated sampling group has multiple blocks, this
address will designate which block's data will be displayed. Block
numbers are specified in Bin format.
You can change the displayed data by changing the block number
stored here.
-
If a block number that does not exist is
specified, data will not be displayed.
-
If in the [Mode] tab's Extended area the
[Overwrite old data after finishing the specified cycles] check box
is selected, this address is disabled.
Display Rows
Set the number of lines to be displayed on the screen from 1 to
50.
Display Columns
Set the number of columns to be displayed on the screen from 1
to 25.
Spacing
Select the spacing between rows and columns displayed on the
screen from 0 to 10 pixels. This can only be set when the [Data
Border] is set to [No Border]. When drawing a ruled line freely,
draw a line within the width of the spacing so that it may not
overlap the cells.
Edit Data
Specify whether or not displayed data can be edited. If this is
designated, touching a displayed Date/Time or numeric value cell on
the screen directly will allow you to change the value.
-
If you change the block number while editing
data or move a cell being edited off the screen with a scroll
switch, the value will not be changed and data edit mode will be
canceled.
-
A keypad needs to be placed on the screen to
edit data.
Interlock
When [Edit Data] is designated, select whether to use the
Interlock feature (allows data editing only when a condition is
satisfied).
Use an Address
This function only allows input when a bit designated via
[Interlock Address] is in a state that has been selected via [Touch
Enable Condition]. Select the check box to use Interlock.
Address
Specify the bit address that represents an Enable condition for
allowing cell touch. Touch is enabled (disabled) depending on the
state of this address.
Touch Enable Condition
Select the enable condition for allowing the cell touch
|
Touch Enable Condition
|
Address Status
|
Touch Enabled/Disabled
|
|
When Bit is ON
|
ON
|
Touch enabled
|
|
OFF
|
Touch disabled
|
|
When Bit is OFF
|
ON
|
Touch disabled
|
|
OFF
|
Touch enabled
|
Use Security Level
Select whether to use the security function for each part. When
logged in with a Security Level higher than that set for the part,
Touch Operation will be enabled.
Level
Set the Security Level of the part from 1 to 15.
Data Border
Select the type of data border from [No Border], [Border], or
[Border with Item Name Fields].
Clear Color
Select a color for the portion with no text displayed.
Blink
Select the blink and blink speed.
Calculation Part Scroll
Designate whether or not to scroll the calculation data portion
together with the data portion. If this is not designated, the data
calculation portion will be displayed on the screen.
This cannot be set when [Overwrite old data when designated
block count finishes] is set to the sampling data. The calculation
data is not scrolled.
Get Operation Log
Specifies whether to record the Operation Log. You can specify
only when you select the [Edit Data] check box.
