Write
Select whether or not to write the sampling data stored in
backup SRAM (or DRAM) to the internal device of the display
unit.
Write Trigger Bit Address
Set the address to control data writing to internal device
addresses. When the bit address is set to ON, sampling data is sent
to the internal device.
Specify Write- to Block Number
If in the [Mode] tab's Extended area the [Overwrite old data
after finishing the specified cycles] check box is cleared,
designate whether or not to set the block number to write to the
internal device.
Block Number Storage Word Address
When [Specify Write- to Block Number] is designated, set a word
address in order to store the block number. The data stored in this
address block will be outputted to the internal device.
If no block number is specified, data from Block Number "0" will
be outputted.
Write- to Internal Device Word Address
Select the internal device address where the data will be
stored. The sampling data will be stored starting from this
address.
25.11.6.1 Writing to the
Internal Device
Write Completion Bit Address
Designate whether or not to confirm the completion of
writing to the internal device. If you want to confirm it, set a
bit address. When the data write is finished, this bit will turn
ON.
Include Number of Cycles
Designate whether or not to output the number of data sampled to
the internal device along with the data.
Write
Select whether or not to read total values for each data column,
set on the [Display/Save in CSV] tab, to the internal device.
Write Trigger Bit Address
Set the address to control the writing of calculation data to
the internal device. When this bit address turns ON, the
calculation values for each Data column set on the [Display/Save in
CSV] tab are written to the internal device.
Specify Write- to Block Number
If in the [Mode] tab's Extended area the [Overwrite old data
after finishing the specified cycles] check box is selected,
designate whether or not to set the block number to write to the
internal device.
Block Number Storage Word Address
When [Specify Write- to Block Number] is designated, set a word
address in order to store the block number. The totals data stored
in this address block will be outputted to the internal device.
If no block number is specified, totals data from block number
[0] will be outputted.
Write- to Internal Device Word Address
Select the internal device address where the totals data will be
stored. The calculation data will be stored starting from this
address.
25.11.6.1 Writing to the
Internal Device
Write Completion Bit Address
Designate whether or not to confirm the completion of
calculation data writing to the internal device. If you want to
confirm it, set a bit address. When the data write is finished,
this bit will turn ON.
