-
You can set up one Remote PC Access Window
Display on one screen. Do not use [Call Screen] or any other
features and display multiple Remote PC Access Window Displays. The
entire project is limited to eight displays.
-
You can set the remote PC access window display
for only base screen display. The remote PC access window display
does not work on the window screen.
-
In "Bit Address", the window opens when the bit
is ON, and closes when the bit is OFF. to turn ON or OFF the start
bit takes more than one communication cycle or display scan time to
find the bit state.
-
Remote PC access window display uses one local
window. Therefore, you can display up to 2 (if you use the global
window in the local window, you can display up to 3.) on the window
parts and remote PC access window display at the same time. If you
display 2 on the window parts, you cannot display on the remote PC
access window display.
-
If you display the remote PC access window
display, only one window part can be allocated to the same screen.
The start sequence for the window part and the remote PC access
window display must have the start bit turned on first. If the
start bit is turned on at the same time, the order of when parts
display cannot be controlled.
-
Remote PC access window display displays in the
same direction as [Landscape], even if you set [Portrait] in for
the [Orientation].
-
When there is a communication error between the
Remote PC Access Window Display and another object on the same
screen, the Remote PC Access Window Display will not run. Either
restore the communication error, or draw a Remote PC Access Window
Display on a separate screen.
