When automatically transferring from the device/PLC to the CF
Card or USB storage device, you can automatically allocate file
numbers to create new files. (This has no effect on automatic
transfers from the CF Card or USB storage to the device/PLC.)
Automatically Assign File Numbers
Enable this feature when reading data from the device and saving
to a CF Card/USB storage as a CSV file. Numbering occurs until the
designated [End]. After that, data is not transferred. to overwrite
existing files and continue transferring, use [Loop] or [Resume Bit
Address].
26.10.4 About Automatic
Numbering
Loop
Specify whether to enable loop action, in which when the File
Number reaches the designated [End] and a new file is created, the
oldest file is deleted and files are overwritten in order beginning
with [Start].
Resume Bit Address
Designate whether or not to set a bit address to resume
transmission when the file number has reached the designated
[End].
When this bit address is turned ON and after the [Control Word
Address] is turned ON, files are created from the designated
[Start].
Full Bit Address
Confirms that the file number has reached the designated [End].
This bit address turns ON when File Number reaches the [End].
CSV Data Output
Defines how to format data when output to a CSV file.
This setting is available when the condition setting [Display
Format] is [Float].
Sets whether to round off digits. Numbers are
truncated if not rounded.
In the [Digits] field, define the number of
output digits from 1 to 17. This includes the number of [Decimal
Places].
The allowable range for [Decimal Places] should be less than the
value set in [Digits].
