If you write the above commands, all bits
except Bit 2 in the address "0011" will turn OFF. to turn ON only
Bit 2 without changing the other bits, read out the address "0011"
data with the read-out command and then send the write command to
change only Bit 2 of the read-out data.
The display unit may not update the display if
write commands are sent continuously.
While printing the displayed screen, "0001"
(status address) Bit 2 (printing bit) in the internal device
(#MEMLINK) of the display unit is ON. After printing, this bit
automatically turns OFF. Create a [Script] to turn OFF the address
"0011" Bit 2 after making sure this bit has turned OFF.
