Remote PC Access
Key Code
Set an RPA function key code.
GP-Viewer EX Key
Code
Set a GP-Viewer EX function key code.
Ethernet
Multilink Settings
Set the display unit operation mode when using the Ethernet
Multilink function. [Master] or [Slave] are the
available options.
[Master]. After
selecting this option, go to the next screen by touching the arrow
button displayed at the bottom right of the screen. [Allow Connection Only to Specified IP
Address]. Select this option and touch the address. In the
keypad, enter the address of the allowed connection.
After selecting [Slave], touch the arrow button and specify the
IP address of the master to be connected.
-
Do not enter the IP address of this display
unit as the master IP address.
-
You cannot use [Ethernet Multilink Settings]
for the following.
-
When the display unit project is not set up
with Ethernet Multilink.
-
When user memory is initialized.
Operation
Lock
Set the operation lock function.
Enable Operation
Lock
Select this option to lock touch operations on other display
units while one of the other display units is in operation.
Lock on Screen
Touch
Select this option to prevent touch operations on other display
units upon touching a display unit screen.
Automatically
Cancel Timer (Sec.)
When touch operations on the display unit that activated the
lock stop are locked, set the period in seconds until the operation
lock is released.
