Adjust
the settings for the Ethernet connection. These settings are used
for communicating with devices and PLCs, sending data during GP
setup or project file transfer, or when using Pro-Server EX
software.
Go to offline mode and touch [Main Unit Settings] on the item
changeover switch.
[Main Unit
Settings] screen opens. Touch [Ethernet Local Settings].
[Ethernet
Local Settings] screen opens. Touch the IP address input
field to display the numeric touch keys and then enter an IP
address. (For example, 192.168.0.1)
For details about the IP address setting, ask
your network administrator.
Using the same steps, specify the [Subnet Mask], [Port], and [Gateway].
The [Port] number specified here is used
for set up via Ethernet, for transfer of project files, and for
communication with Pro-Server EX. Do not change the initial value
[8000].
[Exit]
saves the changes and restarts the display unit.
