M.3.1 Checking the communication settings
for the connected device
You can adjust or check the
communication settings for the connected device. Set these options
so that they match with the communication settings of the connected
device. The setup items vary depending on the device being
connected.
When using GP-4100 series, this step is
unnecessary.
[Device/PLC
Settings] screen opens. Confirm the settings. to change
settings, touch the associated item.
* When changing settings, touch [Exit] to save the changes. After
saving, the display unit will restart.
When using GP-4100 series, touch [Top] to return to the initial
screen. Touch [Exit]
and in the confirmation screen, touch [Save changes and exit].
[Communication]
[Communication]. Touch this item to
adjust communication settings.
[Device]
[Device]. Use this option to adjust
the parameters of each connected device.
[Option]
When RS-232C is used, you can change the
signal for pin number 9.
[Communication], [Device], and [Option] parameters are different
between device/PLC series. Please refer to the Device/PLC
Connection Manual. However, you should use [Timeout], [Retry], and
[Wait to Send] with their initial settings.
Ethernet connection
Go to offline mode and touch [Peripheral Settings] on the item
changeover switch.
For GP-4100 series, touch the [Device/PLC]
button.
When using GP-4100 series, this step is
unnecessary.
[Device/PLC
Settings] screen opens. Confirm the settings. to change
settings, touch the associated item.
* When changing settings, touch [Exit] to save the changes. After
saving, the display unit will restart.
[Communication]
[Communication]. Touch this item to
adjust communication settings.
[Device]
[Device]. Use this option to adjust
the parameters of each connected device.
[Communication] and [Device] parameters are different
between device/PLC series. Please refer to the Device/PLC
Connection Manual. However, [Timeout], [Retry], and [Wait to Send]
are recommended to be used with their initial settings.
