Go to offline mode and touch [Peripheral Settings] on the item
changeover switch.
[Peripheral
Settings] screen opens. Touch [I/O Driver] and then [STD Driver].
[STD
Driver] screen opens. Touch [Terminals] to confirm the current
configuration of the input/output terminals.
When the LT33** series is used, it displays the
configuration of input terminals X0 to X15 and output terminals Y0
to Y15. The bottom of the screen shows [X8-X15: Std. Input] and
[Y4-Y15: Std. Output].
[Back]
or [←] returns to the previous screen. Next, touch [I/O Monitor].
[I/O
Monitor] screen opens. The corresponding bit numbers in
[Input] are highlighted
to match the ON/OFF status of corresponding inputs from the
connected device. [Output]: You can confirm the ON/OFF
status of each output by touching the corresponding bit number.
With the LT33** series, you can check the
status by using inputs and outputs 0 through 15 respectively.
If the connected device is operating normally,
check the project file settings in GP-Pro EX. If the connected
device does not operate normally, check the wiring between the LT
series and the connected device, and then check the following
items.
