M.9.1 Checking whether the logic program is
operating properly
Check whether the logic program
is operating properly on the display unit, or check the
instructions in the logic program. You can also check whether the
logic program is operating properly and view a list of the variable
names used in the logic program and their current values.
Logic Monitor
The entire logic program is monitored. You can use Logic Monitor
to check the status of the program operation and the variables used
in the instruction.
Transfer the logic program (project file) to the
display unit.
Touch either the upper right corner and then the
lower left corner, or the upper left corner and then the lower
right corner on the panel to display the offline system menu. Touch
the [Logic Monitor]
switch from the third menu.
When the [Logic Monitor] switch is touched,
the following screen appears. You can check whether the transferred
logic program is operating properly.
Exit the Logic Monitor. [Toolbar]: Touch the button then
touch .
[Quit] returns to the
RUN screen.
Address Monitor
The variables used in the logic program are monitored.
The name and current value of the variable can be checked. When
[Address Format] is used in the logic program, the addresses and
current values can be checked.
Even when the model does not support a logic
program or when a logic program is not used, Address Monitor is
available as long as the variables for the symbol variable are
registered.
Touch either the upper right corner and then the
lower left corner, or the upper left corner and then the lower
right corner on the panel to display the offline system menu. Touch
the [Address Monitor]
switch from the third menu.
The following screen appears, showing the names of
the variables specified in the transferred project file as well as
their current values.
Exit the Address Monitor. [Toolbar]: Touch the button then
touch .
[Quit] returns to the
RUN screen.
.
