The [Request Special I/O Parameter Change]
and [Special I/O Parameter Change Completed] operations reflect all
the CH parameters you change.
The acceleration/deceleration pulse output
is OFF then starts up, and outputs one time at ON→OFF. The Output
pulse count is updated every ON→OFF. When you forcibly stop the
pulse output, the output stops no matter what state the pulse is
in. Therefore, the pulse output generated during the forced stop
might not be counted in some cases.
Pulse outputs have a limit to the output
frequency and pulse count.
For details, see 31.5.13
Restrictions.
Right after transferring, operations use
parameter values set up in GP-Pro EX. Any restarts, which include
going off-line, reset, and turning power OFF, use stored system
variables as parameters.
