You can define the end position using your
mouse. Click where the pointer changes back to
as an end point to
insert the branch.
You can click the start point of the branch in
step 1, and drag to the right of the NO instruction (Normally
Open). Release the left mouse button when the pointer changes from
to
and the branch will
be inserted.
The branch end is not valid in areas where the pointer is shown as
. If this symbol
shows, the branch will not be inserted after you release the left
mouse button.

While multiple instructions or shunts are
selected, a branch for detouring from the instruction will be
inserted when [Insert Branch (B)] is performed.
