32.16.3.3 Explanation of the SQRT and SQRTP Instructions
The SQRT/SQRTP instructions both calculate the square root. When
the SQRT instruction is executed, the square root of S1 is
calculated and the value is saved in D1.
The SQRT/SQRTP instructions always pass power. If the variables
designated in operands S1 and D1 are not the same type, an error
will occur when using the SQRT/SQRTP instructions. Designate the
same variable type in all operands S1 and D1.
Refer to the following for specifying a constant.
When operand D1 is a float variable
When 0f (zero and lower case "f") is input, the following values
are interpreted as float values.
When operand D1 is a real variable
When 0r (zero and lower case "r") is input, the following values
are interpreted as real values.
When calculating data in a specified
array
Specify the array using Data [0] or Data [N] (N indicates an
integer variable).
When operands S1 and D1 specify the entire array, an error will
occur even if the specified variables are the same type.
Confirming Execution Results
|
