32.15.4.1 Calculating the Number of Steps When Setting Operands
- RCR/RCRP
The following table lists the specifiable content of operands
S1, S2, and D1 for the RCR and RCRP instructions.
The actual number of steps in the RCR and RCRP instructions
depends on the specified operands. The following describes how to
calculate the number of steps.
Number of steps in operand S1 + Number of steps in operand S2 +
Number of steps in operand D1 + 1 = Total number of steps in one
instruction
For example, calculating the number of steps
in RCR and RCRP instructions
(For the number of steps in an operand, refer to the operand
settings as follows.)
{Data_1 =1 step} + {10 = 1 step} + {Data_2 = 1 step} + {1 step}
= 4 steps One last step is included in the instruction. Be sure to
add that one step.
|
