Use an OUTN instruction to invert and output an
ON or OFF result. Use the SET and RST instructions to turn ON or
OFF external outputs or internal coils.
Only one OUTN instruction can be used in one
rung. If a branch instruction is used, multiple OUT instructions
can be used.
Place OUTN instructions immediately to the left
of the right power bar.
Program Example
Point A When the bit variable (Start) turns ON, the bit variable
(Motor) of the OUTN instruction turns OFF.
Point B When the bit variable (Start) turns OFF, the bit
variable (Motor) of the OUTN instruction is turned ON.
To retain the state when the power is turned
OFF, set the symbol variable to Retentive.
Use a retentive address for the address format. (The retentive
setting cannot be used for external inputs and outputs.)
When using multiple OUT and OUTN
instructions
The example above shows how to use multiple OUT instructions by
branching OUT instructions. An error will occur if OUT_001 and
OUT_002 are placed in a series.
