32.16.4.3 Explanation of the BCNT and BCNTP Instructions
The BCNT/BCNTP instructions both count bits. When the BCNT
instruction is executed, the ON bits in S1 data are counted and the
number of ON bits is saved in D1. The BCNT/BCNTP instructions
always pass power. If the variables designated to operands S1 and
D1 are not the same type, an error will occur when using the
BCNT/BCNTP instructions.
Designate the same variable type in all operands S1 and D1.
Refer to the following for specifying a constant.
When operand D1 is an integer variable
When operand D1 is an integer variable and
you want to input hexadecimal values in operand S1.
When 0x (zero and lower case "x") is input, the following values
become hexadecimal values.
When Calculating Data in a Specified Array
(Integer Variable Array)
Specify the array using Data [0] or Data [N] (N indicates an
integer variable).
When operands S1 and D1 specify the entire array, an error will
occur even if the specified variables are the same type.
|
