For details about placing parts or setting
addresses, shapes, colors, and labels, please refer to the "Part
Editing Procedure". 8.7.1 Editing Parts
On the [Screen (S)] menu, click the [New Screen
(N)] command or click .
In [Screens of Type] select [Base], in [Screen]
enter 10, and click [New].
Create a background on the screen to be called.
When the
[Display Type] of a Picture Display is [State Display], called
pictures will be overlaid. to avoid visible overlapping, create a
background in the called screen to clear the previous picture.
Draw a picture on the screen to be called.
Repeat steps 1 to 4 to create additional screens
Base 11, Base 12, and Base 13.
To position a called screen, you specify where
its center will be placed on the destination screen. Therefore,
drawing your picture with a vertex at the center of the drawing
area may make it easier to later position this picture on the
destination screen.
Click the [Base 1] tab. From the [Parts (P)] menu,
point to [Picture Display (F)] or click , and place the Picture
Display anywhere on the screen.
Double-click within the border of the Picture
Display part to open the Picture Display dialog box.
Set up the [Screens of Type] and [Specify Screen].
For example, in [Screens of Type] select [Base Screen], and in
[Specify Screen] select [Constant].
Click [OK] to specify the position of the called
pictures.
When you select
[Base Screen], [Image], or [Image CF Card] in [Screens of Type],
the Picture Display will place the display position pointer
on the screen. This
pointer determines the center of the screen you want to call.
.
, and place the Picture
Display anywhere on the screen.
on the screen. This
pointer determines the center of the screen you want to call.