For details about placing parts or setting
addresses, shapes, colors, and labels, please refer to the "Part
Editing Procedure". 8.7.1 Editing Parts
Create a screen on which the load operation will
take place. (For example, Base1)
On the [Screen (S)] menu, click the [New Screen
(N)] command or click .
In [Screens of Type] select [Base], in [Screen]
enter 10, and click [New].
Create a screen to be called. Draw a rectangle the
same size as the rectangle on Base 1. Set its fill color to red.
When this screen is called as a Picture Display, it will affect the
color in the overlapping area on the call destination screen, but
will not completely obscure the original contents.
When the [Display Type] of a Picture Display is
[ON/OFF Display] you select the [Clearing Action] check box, the
color of the called picture may change where it overlaps with the
destination screen background. 9.8 8-color Combinations
To position a called screen, you specify where
its center will be placed on the destination screen. Therefore,
drawing your picture with a vertex at the center of the drawing
area may make it easier to later position this picture on the
destination screen.
Click the [Base 1] tab. From the [Parts (P)] menu,
point to [Picture Display (F)], or click , and place the picture
display on the screen.
Double-click within the border of the Picture
Display part to open the Picture Display dialog box.
Define the [Screens of Type], [Specify Screen],
[Display Method] and [Clearing Action]. For example, in [Screens of
Type] select Base Screen, in [Specify Screen] select Constant, in
[Display Method] select ON Display, and select [Clearing
Action].
If [Clearing
Action] is not selected when you display pictures of different
sizes by turning them ON or OFF, the pictures that already display
will not disappear. Instead, new pictures will be overlaid. to
avoid visible overlapping, create a background for clearing as
follows:
Click [Select Display], select Screen 10, and then
click [OK].
The [Picture Display] dialog box appears again.
Click [OK]. When the display position pointer displays on the
screen, drag it to specify the position of the called picture.
When you select
[Base Screen], [Image], or [Image CF Card] in [Screens of Type],
the Picture Display will place the display position pointer
on the screen. This
pointer determines the center of the screen you want to call.
.
, and place the picture
display on the screen.
displays on the
screen, drag it to specify the position of the called picture.
