Addresses with cleared [Addresses to Convert]
check boxes will not be converted. If you want to convert an
address in the same device individually, select the check box of
the address you want to convert and click [Convert].
Addresses with the same device name set in
[Addresses to Convert] will be converted. In the procedure example,
only addresses with the device name X will be converted to the
device name M.
Even when a device name is the same, if the
address set in [Addresses After Conversion] is a bit address, only
bit addresses will be converted, if it is a word address, only word
addresses will be converted.
Addresses are converted using the same
increments as the [Addresses to Convert]. For example, if the
setting before conversion is X0100, X0200, X0300, then the
addresses after conversion are M0200, M0300, M0400.
If any addresses after conversion are smaller
than the start address of the device, they will be converted to the
start address.
If any addresses after conversion are larger
than the end address of the device, all overflow addresses are
converted to the end address.
