You can make minute adjustments to the width or
height of parts and drawings. From the [View] menu, point to [Work
Space] and select [Properties].
If you set the width or height to an even
number, it will be drawn with one less dot on the display unit.
When editing the scale (bar) after drawing it
on the screen, click inside its area while selected, or right-click
and from the shortcut menu select [Edit Vertex], to display a
yellow line. Change the length of the scale by dragging the yellow
line.
When editing a scale (arc), change the [Start
Angle] and [End Angle] by dragging the yellow dots that display
while the scale is selected. Or, you can click inside the scale
area while it is selected, or right-click and from the shortcut
menu select [Edit Vertex], to display a yellow line. Change the
length of the scale by dragging the yellow line.
When setting up a scale (arc) and its [Axis
Position] is set to [In], the scale [Length] should be less than
half the width or height. When the scale [Length] is greater than
half the width or height (when the yellow points overlap), the
scale will display differently between the editor and display unit.
to place a scale on
the screen. Double-click the placed [Scale] to display the
following dialog box.
