Converts the addresses set on the specified screens as a
block.
From the [Project (F)] menu, point to [Utility (T)]
and select [Convert Addresses (A)]. The [Address Block Conversion]
dialog box appears.
Click [Option] to display the setting items to be
converted.
In the [Converted Items] area select [Screen] check
box, then select the screen types and screen numbers.
Select the [Address Type] from [Bit] or [Word].
(For example, bit)
In the [Address to Convert] area, define the start
address (for example, M10) and end address (for example, M17).
In the [Address to Convert] fields, you cannot
define different registers for the start and end addresses.
In the [Address After Conversion] area, define the
first address after conversion (for example, M200).
Click [Convert]. When the completion message
appears, click [OK].
If the total number of addresses (End Address -
Start Address) before conversion is greater than the total number
of addresses (End Address - Start Address) after conversion, the
last device address is assigned to remaining addresses.
