Please refer to the following for models that
support Ethernet Multilink settings.
1.5 Supported
Features
GP-Viewer EX can be connected only to the
master.
Refer to the following for information on
GP-Viewer EX.
Use the Computer to Display and
Operate Data on the Display Unit
If you control the same PLC/device address in
parts on multiple display units, it may not operate properly.
For example, if you set up the same address in the Data Block
Display Graph's control word, even though you update the graph on
the Master display unit the graph will update on Slave display
units but not the Master display unit. to prevent this type of
behavior, use a different address on each display unit.
In the [System Settings] window's [Display
Unit] tab, if the [Screen Settings] area's [Reflect in Device/PLC]
check box is selected, and the same items are used on Master and
Slave display units, the [System Area Start Address] will be the
same for all display units.
For example, if you change a shared screen number , all Master and
Slave display units will synchronize their screen displays.
For mutilink feature of serial connection,
please refer to Device/PLC Manual.
