-
If the [Save Data in] is set to [Internal Device]
and [Read Completion Bit] is set, turn OFF the [Read Completion
Bit] when input is complete. The display unit will not read code
data without turning the read completion bit OFF.
-
When the [Parity Bit] is [None] and the
communication speed settings for the barcode reader are different
from those of the display unit, the system may read invalid data
because it cannot detect errors. Use the same communication
settings for both the devices.
-
When you do not use the [Input Complete Bit
Address] setting, reading in data continuously will overwrite
previous code data.
-
If switching between screens while entering data,
the switching process takes priority and the data being input is
ignored.
-
If [Input Barcode] is not set in the [Data Entry]
tab for the Data Display, the read code data is not written to the
Data Display.
-
If the number of the read code data exceeds the
[Display Characters] set for a Data Display, the data cannot be
properly displayed on the Data Display. The maximum number of
display characters that can be set in a Data Display is 100
(single-byte) characters.
-
One barcode reader can be connected to either the
COM1 or USB port.
When connecting two barcode readers at the same time, store data in
separate locations of [Save Data in] from [Data Display] and
[Internal Device] or use different storing address by selecting
[Internl Device].
If both devices choose to save data in the [Data Display], the
system may not work properly.
