Configure the items, the number of characters, and the date/time
format displayed in the Alarm Part. The item names are not
displayed on the display unit's screen. To display the item names,
set them by selecting [Extended].
Left Margin
Select the spacing between the left-most item name and the
border. Set a value so that the total of [Display Characters] and
[Left Margin] is within 160 single-byte characters.
Message Spacing
You can define this when [Alarm Parts]-[Basic]-[Message Display
Method]-[Multiple line display] is selected. The maximum number of
characters that can display on one line is 160 characters. The
number of characters in the message that can display on one line is
160 characters minus the total of [Display Characters] and [Left
Margin]. Set [Display Characters] from 0 to 20.
Select Items to Display
From [Date], [Trigger], [Message], [Acknowledged], [Recovery],
[Occurrences], [Elapsed Time], [Level], and [Address], specify
items to print.
Displays the date and time when the alarm was
triggered.
Displays the time when alarm was
triggered.
Displays Alarm Message.
Displays the time when alarm message was
confirmed.
Displays alarm recovery time.
Displays the number of times alarm was
triggered. The maximum count is 65535.
Displays the total duration of time when the
alarm was in the triggered state. The maximum duration is 9999
hours 59 minutes 59 seconds.
Displays the Alarm Message importance
level.
Displays data when an Alarm is triggered.
Display Characters
Set the number of characters displayed for each item. Set a
value so that the total of [Display Characters] and [Left Margin]
for the item is within 160 characters.
-
Line to display items other than alarm
messages
Characters of items set in [Select Items to Display] other than
messages + Left Margin
-
Line to display alarm messages
Number of characters in the message + Left Margin + Message
spacing
-
When using GP-4100 series and the number of
characters in the alarm message exceeds the display characters,
only the message portion appears in the banner display.
Display Order
Set the display order of all items. Items starting from the top
of this list are displayed on the Alarm part from left to
right.
-
The separator and Addresses 1 to 8 cannot be
moved between Date and Level.
-
When [Alarm Parts]-[Basic]-[Message Display
Method]-[Multiple line display] is selected, [Message] will be
displayed on a separate line from other items and not in the
list.
Format
Set the date and time format.
Date
Select the Date display format: [mm/dd/yy], [mm/dd], [yy/mm/dd],
or [dd/mm/yy].
Time
Choose a display format for the time from [12:00], [24:00],
[12:00:00] or [24:00:00].
