Pro-face America Technical Resources

FAQ
 I am Trying to Display the Image from a Video Camera in My AGP, but the Image is not Displayed.
Check the following in the order listed.

1)

 Is the image of the video camera displayed in offline mode?
♦

If the image is displayed in offline mode:
1. Please confirm that the connections of the [Video Camera with VM Unit], and [VM Unit with Display] are correct.

♦
If the image is NOT displayed in Offline Mode:
1. Please open the [Video Module Settings] window and check the following:
Confirm that the channel number of [Display settings] is matched to the channel used on the VM unit.
2. Please open Base Screen and confirm below discriptions depending on [Video Layout] of VM Unit Display which has been placed.

a. When the Video Layout is set to [Always On]
* Please confirm that the VM unit window which has been set is set as [Video Number].




b. When the Video Layout is set to [Window On/Off]
* Please confirm that the VM unit window which has been set is set as [Video Number].
* Is the bit address for [Window Display Bit Address] ON?




c. When the Video Layout is set to [Indirect]
* Is the word address assigned to [Window Display Word Address] operating properly?
Window display word address is used to specify the displaying windows or to control Display/Delete by using sequential 4 words form the specified address.

Please input the number of the window to display on [Window Number] of the address which has been set, and confirm that Bit 0 of [Control] is ON.

The datum which are stored as below.

+0
Control
 To display the designated window when Bit 0 is ON
+1
Window Number
 To set the windows to display
+2
Display Location (X Posit.)
 To set the Location of X Posit. to display
+3
Display Location (Y Posit.)
 To set the Location of Y Posit. to display




↑Back to page top --> Close this page
Protection of Personal Information | Trademark Acknowledgments | Terms of Use
© Copyright 2004-2012. Pro-face. All rights reserved.