FAQ > AGP3000 > The AGP unit displays an error message: "There are features unsupported by this model. Please check the settings then transfer the project again."

Technical Resources

FAQ

The AGP unit displays an error message:
"There are features unsupported by this model. Please check the settings then transfer the project again."

If your AGP unit is an AGP3300 model with the revision number earlier than Rev 4, and you transfer to a display unit with the [Revision] set to [Rev*-4 Greater Than Or Equal To], the following message will appear and the AGP may not run properly. Data stored on the AGP before transferring is also deleted.

If the revision number of your AGP model is earlier than Rev. 4, please make sure to set [Revision] to [Rev*-4 Less Than]. When designing the screen display, do not use any features unsupported by models earlier than Rev 4.

NOTE

-	Transfer operations include all transfer operations, such as CF Card Connection, Memory Loader, and transferring between the computer and the display uint.

↑Back to page top

→ Close this page

Protection of Personal Information | Trademark Acknowledgments | Terms of Use