 |
|
| USB devices are not recognized by the HMI. |
|
The following USB devices are supported by GP-Pro EX Ver. 1.0 and higher.
|
Printers (models are limited.) |
|
Bar Code Readers |
|
USB Hub |
|
Project Transfer Cable |
NOTE: Using a USB Hub
|
When multiple devices are connected using a USB Hub, the power, 0.5A supplied from the AGP's USB port, may run short.
If this happens, the AGP, which monitors the power, will cut off the USB devices. To determine if this is causing the devices from
being recognized, unplug the hub and connect each USB device separately. Then check if it's recognized or not. If the devices are
recognized individually, then you need to limit which devices are plugged into your hub. |
|
|
